Unicorn Nap Bath Bomb Mold
The mold contains 3 pieces: base, sleeve, and plunger. Mold colour may vary from photo.
Approximate final bath bomb size:
10.5 cm Wide x 8 cm Tall x Width dependent on how much mix you put into the mold.
4" Wide x 3" Tall x Width dependent on how much mix you put into the mold.
Bath bomb in photo weighs approximately 150 g / 5.25 oz (bath bomb not included).
Our molds are made of PLA which is derived from renewable resources like corn starch or sugar cane. To clean your mold, rinse under cool water and towel dry. PLA is heat sensitive and can retain water, so molds should never be put in the dishwasher or soaked, and should not be rinsed with warm or hot water.
To use: Place the sleeve on the base. Add your bath bomb mixture. Place the plunger on top, and then simply press down hard. You can either push the top and bottom piece out of the sleeve by hand, and then unmold, or you can use the plunger to push the mold pieces out. Wipe away any mixture on the inside of the pieces before making the next bath bomb.
Price and Currency
Price is for one (1) 3D printed mold in US dollars
Bath Bomb Not Included
This is for a mold only - bath bomb is not included.