This is a 3D printed mold for people who make their own bath bombs and is designed to be used by hand. 
 
The mold contains 3 pieces: insert, sleeve, and top.  Mold colour may vary from photo.
 
Finished bath bomb has an approximate total circumference of 5.7 cm / 2.25".  Height of finished bath bomb is dependent on how much mix you put in the mold. Bath bomb in photo weighs approximately 70 grams/ 2.6 ounces, and is approximately 6.5 cm/ 2.5" tall. Hole in finished bath bomb is approximately 3.5 cm /1.4" deep (bath bomb not included).
 
Our molds are made of PLA which is derived from renewable resources like corn starch or sugar cane.  To clean your mold, rinse under cool water and towel dry.  PLA is heat sensitive and can retain water, so molds should never be put in the dishwasher or soaked, and should not be rinsed with warm or hot water.
 
Molds are printed to order, so we do not offer refunds or cancellations on any orders. If you have any issues with any item, please contact us directly, and we will work with you. If you have any quality issues, please contact us directly.
 
To use:  Place the insert into the sleeve.  Add your bath bomb mixture, leaving a hole in the center.  Place the top piece on top, and then press down. You can either push the top and bottom piece out of the sleeve by hand, and then unmold, or you can use the plunger to push the mold pieces out.  Wipe away any mixture on the inside of the pieces before making the next bath bomb. Dry the mold upside down (hole facing down). When it is dried, you can fill the hole with other products (like bubble frosting).